Chief K3G310B Operations Instructions download pdf (Page 13)

Installation Instructions K3 Series

Outside Faceplates (K3G310 only)

1. Remove hex head bolt from bottom of faceplate assembly.

(See Figure 19)

2. Slide out removable plate from bottom of faceplate

assembly. (See Figure 19)

Figure 19

3. Remove faceplate assembly from array arm. (See Figure

19)

To Reattach Outside Faceplate Assembly (K3G310

only)

NOTE: Faceplate assemblies may be reattached on the fixed

part of the arm. (See Figure 20)

4. Place faceplate assembly on array arm at desired mounting

position. (See Figure 20)

5. Slide removable plate back into slot at bottom of faceplate

assembly. (See Figure 20)

6. Reinstall hex head bolt removed in Step 1 to secure

faceplate assembly to array arm. (See Figure 20)

Figure 20

Lateral Shift (On Fixed Arm)

NOTE: The procedure below applies when the outside

faceplates have been attached to the fixed arm. If

outside faceplates are still attached to extension arms,

use the extension arms for lateral shift.

1. Loosen knob on top of outside faceplate assembly until

faceplate can slide freely along array arm. (See Figure 21)

2. Adjust lateral position as desired. (See Figure 21)

3. Tighten knob to secure lateral position. (See Figure 21)

Figure 21

Pitch/Roll/Yaw Adjustment

Outside Faceplates

1. Loosen knob on top of faceplate assembly. (See Figure 22)

2. Adjust pitch, roll and/or yaw as desired. (See Figure 22)

3. Tighten knob to secure desired faceplate position. (See

Figure 22)

Figure 22

removable plate

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Chief K3G310B Operations Instructions Page 13