Chief K3G310B Operations Instructions download pdf (Page 11)

Installation Instructions K3 Series

Recessed Mounting Holes

NOTE: If faceplate does not fit into recessed area of display,

proceed with the steps in this section.

1. Determine depth of recessed mounting holes relative to

back surface of display (against which faceplate will

contact).

2. Select proper length spacer and screw from table below:

NOTE: All spacers used should be the same length. If the

recess depths result in multiple spacer lengths, then

select the longer spacer.

CAUTION: Using screws of improper size may damage

your display! Proper screws will easily and completely thread

into display mounting holes.

3. Using Phillips screwdriver, carefully install two selected

screws (J or H) through selected spacers (L or M) into the

upper mounting holes on the display. Thread screws

completely into display, then back out 3 complete turns.

(See Figure 12)

4. Pick up and align display so that screws (K) (installed on the

back of the display in the previous step) fit into the mounting

holes on the faceplate. Lower the display firmly into place.

(See Figure 12)

Figure 12

5. Slide two remaining selected spacers (L or M) in between

faceplate and display, positioning them over the lower two

mounting holes. (See Figure 13)

6. Install two remaining selected screws (J or H) through lower

two mounting holes on faceplate, selected spacers (L or M)

into the lower mounting holes on the display. (See Figure

13)

Figure 13

7. Tighten all four screws. Do not overtighten!

Adjustments

Pivot Adjustment

1. Array arms may pivot toward the front of mount up to 15° per

arm. (See Figure 14)

WARNING: Pivoting array arms toward the back of mount

may cause K3 Series mount to tip over causing serious

personal injury or damage to equipment! Do not pivot arms

toward back of mount! (See Figure 14)

Figure 14

IF recess DEPTH is: THEN use spacer: AND screw:

3/8" or less L (3/8" long) J (M4 x 20mm)

More than 3/8" up to

and including 3/4"

M (3/4" long) H (M4 x 30mm)

(L or M) x 2

(J or H) x 2

Center faceplate

(array stand not shown for clarity)

(L or M) x 2

(J or H) x 2

Center faceplate

(array stand not

shown for clarity)

front

(top view)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Chief K3G310B Operations Instructions Page 11

Comments to this Manuals

Related products and manuals for Flat panel floor stands Chief K3G310B