Chief K3G310B Operations Instructions download pdf (Page 10)

K3 Series Installation Instructions

10. Snap column cap (D) onto top of array assembly (A). (See

Figure 9)

Figure 9

Display Installation

WARNING: Exceeding the weight capacity can result in

serious personal injury or damage to equipment! It is the

installer’s responsibility to make sure the combined weight of

all components located on the K3 Series mount up to (and

including) the display does not exceed 15 lbs (6.8 kg) per

display for the K3F220, K3G220 and K3G310 mounts or 25

lbs (11.34 kg) per display for the K3F120 and K3G120

mounts.

CAUTION: Using screws of improper size may damage

your display! Proper screws will easily thread into display

mounting holes.

NOTE: Supplied screws (H, J and K) may not fit properly for all

displays. See display’s operating instructions for

details.

IMPORTANT ! : When applicable, always install center

display FIRST in order to prevent stand from tipping! If

there are no center faceplates (K3F220 and K3G220), be

sure to support opposite arm when mounting displays to

prevent stand from tipping! If possible, mount displays to

both sides simultaneously.

NOTE: Set height of lower center display prior to installing

other displays. See Height Adjustment Section for

details. Center of display must be at least 18" above

desk surface.

Flush Mounting Holes

1. Position faceplate in desired mounting position. Adjust as

required before proceeding. See Height Adjustment

Section for details.

2. Using Phillips screwdriver, carefully install two M4 x 12mm

Phillips pan machine screws (K) into the upper mounting

holes on the display. Thread screws completely into

display, then back out 3 complete turns. (See Figure 10)

Figure 10

3. Pick up and align display so that screws (K) (installed on the

back of the display in the previous step) fit into the mounting

holes on the faceplate. Lower the display firmly into place.

(See Figure 10)

4. Using Phillips screwdriver, install two M4x12 mm

Phillips pan machine screws (K) through the lower

mounting holes on faceplate into the display. (See

Figure 11)

Figure 11

5. Tighten all four screws (K). Do not overtighten!

NOTE: If roll adjustment is desired for center faceplate, do not

tighten screws.

6. Repeat Steps 1-5 for other displays.

7. Proceed to Cable Management Section.

(D)

(A)

Center faceplate

(array stand not shown for clarity)

(K) x 2

Center faceplate

(array stand not shown for clarity)

(K) x 2

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Chief K3G310B Operations Instructions Page 10

Comments to this Manuals

Related products and manuals for Flat panel floor stands Chief K3G310B