Chief K3G310B Operations Instructions download pdf (Page 12)

K3 Series Installation Instructions

2. When arms are at desired pivot position, lock pivot position

by tightening pivot adjustment screws using 5/16" hex key

(N). (See Figure 15)

Figure 15

Height Adjustment

NOTE: Height adjustment for center displays should be set

prior to installing display. Due to the location of the

height adjustment screws for the center displays, the

center displays will need to be removed in order to

adjust the height. (See Figure 16)

1. Loosen height adjustment screws for specific display that

will be adjusted. (See Figure 16)

2. Adjust arm or display to desired height. (See Figure 16)

3. Tighten height adjustment screws to lock display’s position.

(See Figure 16)

Figure 16

Arm Extension (K3G310 only)

NOTE: For smaller displays or if converting to a 2x1 array,

faceplate assemblies may be removed and reattached

to fixed part of the arm. See Faceplate Assembly

Section - Outside Faceplates for details.

1. Turn arm extension adjustment knob counter-clockwise on

arm to be adjusted. (See Figure 17)

2. Adjust arm extension as desired. (See Figure 17)

3. Turn arm extension adjustment knob clockwise on adjusted

arm to lock position. (See Figure 17)

Figure 17

Faceplate Assembly Removal

Center Faceplate(s)

1. Remove column cap (D) from array column. (See Figure 18)

2. Loosen height adjustment screws for center faceplate

assembly. (See Figure 18)

3. Slide faceplate assembly up through column channel until it

is removed from column. (See Figure 18)

Figure 18

pivot adjustment screws

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Chief K3G310B Operations Instructions Page 12