Chief PWR User Manual download pdf (Page 5)

Installation Instructions PWR

Mount Installation

WARNING: IMPROPER INSTALLATION CAN LEAD TO

MOUNT FALLING CAUSING SERIOUS PERSONAL

INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s

responsibility to make sure the structure to which the PWR is

being installed is capable of supporting five times the

combined weight of the mount and all attachments.

1. Determine mounting location taking into consideration

display size and mount movement.

2. Using a stud sensor locate two wood studs 16” apart on

center. (See Figure 2)

3. Using two people, place mount against wall and level mount

aligning mounting holes in upper and lower wall channels

with studs. (See Figure 2)

4. Use a pencil mark four mounting holes making sure

mounting holes are located as close as possible to center of

studs. (See Figure 2)

5. Drill four pilot holes where the mounting holes were marked

using a 7/32” (6mm) drill bit. (See Figure 2)

6. Install two 5/16" x 2-1/2" lag bolts(G) and two 0.135" thick

washers (H), through mounting holes in upper wall channel

and into pilot holes. DO NOT tighten at this time.

7. Using two people place mount against wall aligning

mounting holes in upper wall channel with lag bolts and

hang mount on lag bolts making sure washers are located

in front of mount.

8. Adjust mount lateral position left until lag bolts are seated in

mounting slots in upper wall channel.

9. Install two 5/16" x 2-1/2" lag bolts (G) and two 0.135" thick

washers (H), through mounting holes in lower wall channel

and into pilot holes. (See Figure 3)

10. Tighten all hardware. DO NOT overtighten!

Figure 2

Figure 3

7/32" x 4

Mounting holes

centered on

studs

(G) x 4

(H) x 4

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Chief PWR User Manual Page 5