Chief PWR User Manual download pdf (Page 10)

PWR Installation Instructions

Roll Adjustment

The PWR allows for the horizontal alignment (Roll)of the display

to be adjusted up to 2° right or left to level the display after

installing.

To adjust Roll:

1. Loosen the roll tension adjustment nut located on the back

side of the faceplate assembly. (See Figure 10)

2. Level display.

3. Tighten roll tension adjustment nut. (See Figure 10)

Figure 10

Swing Arm Tension Adjustment

Swing arm tension is pre-set at the factory and is adjusted to

accommodate displays with weights near the top of the mounts

capacity.

If smaller displays are used it may be difficult to reposition the

display after mounting. Swing arm tension can be adjusted to

compensate for smaller display by:

The display must be mounted prior to adjusting swing arm

tension.

1. Locate the adjustment bar (H) and adjustment wrench (J).

2. Place adjustment bar (H) into socket head cap screw

located at swing arm pivot point. (See Figure 11)

NOTE: The display may need to be repositioned in order to

gain access to the tension adjustment screw(s).

3. Check swing arm tension. If desired tension is present,

tension adjustment is complete. If additional tension

adjustment is required, repeat steps 2 thru 4 until desired

tension is achieved.

NOTE: If changing from a smaller display to a larger display

may be necessary to increase swing arm tension.

Figure 11

4. Using the adjustment wrench (D), turn adjustment bar (C)

clockwise to increase swing arm tension or

counterclockwise to reduce swing arm tension. (Small

adjustments of 1/8 turn or less are typically all that is

required to achieve desired tension.) (See Figure 12) and

(See Figure 13)

Figure 12

Figure 13

Socket Head

Capscrew

(D) x 1

DECREASE

INCREASE

1 2 ... 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Chief PWR User Manual Page 10

Comments to this Manuals

Related products and manuals for Televisions Chief PWR