Chief KWS220B Instruction Manual download pdf (Page 9)

Installation Instructions Model: K-Series

Figure 14: Dual / Triple Display - Recessed Mount

CAUTION: Using screws of improper size may

damage your display! Proper screws will easily and

completely thread into display mounting holes.

7. Using Phillips screwdriver, install four selected

screws through the mounting holes in Centris bracket,

through the spacers, into the display (See Figure 14).

Tighten all four screws. Do not overtighten!

8. Proceed to "ARRAY ASSEMBLY."

ARRAY ASSEMBLY

(DUAL / TRIPLE DISPLAY;

ALL EXCEPT KCY-210/-220)

1. Verify that you have the following parts:

2. Install pin and spacer(s) into upper mount arm bore

(See Figure 15):

• All Except KSA-1015/-1016:

Insert pin (60) and spacer (80).

• KSA-1015/-1016 ONLY:

Insert large spacer (90), followed by large end of

pin (70) and small spacer (80).

Figure 15: Assemble Array

3. Install array (10) onto pin (60 or 70, as applicable)

(See Figure 15).

4. Insert and hold nut (100) into lower mount arm bore

(See Figure 15).

5. Insert screw (20 or 30, as applicable) through washer

(50), washer (40), washer (50), array (10), array/

mount arm assembly, and into nut (100) (See Figure

15). Tighten screw as required using 3/16" hex key.

6. Slide the Centris head (dual knob assembly) onto the

array (10) (See Figure 16). Ensure both the top and

the bottoms of the Centris head are engaged into the

corresponding slots in the array (10).

Figure 16: Install Display

7. Position the displays as desired and tighten the

Centris head knob closest to the array (10). See

"ADJUSTMENT" for additional information.

Item Description Qty

10 ARRAY 1

20 SCREW, Button Head Cap, 5/16"-18 x 4"

(Used for Pivot / Swing Arm)

30 SCREW, Button Head Cap, 5/16"-18 x 5"

(Used with Height Adjustable Arm)

40 WASHER, 5/16", UHMW (plastic) 1

50 WASHER, 5/16", Stainless Steel 2

60 PIN

(ALL EXCEPT KSA-1015/-1016)

70 PIN

(KSA-1015/-1016 ONLY)

80 SPACER, UHMW (plastic) 1

90 SPACER, UHMW (plastic)

(KSA-1015/-1016 ONLY)

100 NUT, Nylock, 5/16"-18 1

110 SCREW, Button Head Cap,1/4"-20 x 1/2" 2

120 NUT, Square, Machine Screw, 1/4"-20 2

20 or 30

(4 places)

40 or 50

(4 places)

Centris

Bracket

20 or 30

60 or 70

(60 shown; 70 similar)

100

(20 shown; 30 similar)

Centris Head

NOTE: Dual display shown; triple display similar.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Chief KWS220B Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for Flat panel accessories Chief KWS220B