Chief KWS220B Instruction Manual download pdf (Page 11)

Installation Instructions Model: K-Series

Figure 19: Allowable Arm Area

7. Repeat Steps 2. through 6. for second mount arm

assembly (10).

8. If desired, proceed to "MODIFICATION." Otherwise,

proceed to:

• "CABLE MANAGEMENT" (for display with

RECESSED mounting holes), or to

• "DISPLAY INSTALLATION" (for all other display

configurations).

MODIFICATION

If desired, each arm assembly (10) may be modified to

prevent movement of the outer arm relative to the inner

arm (without loosening the adjustment screw).

NOTE: Spacer (shipped configuration) will allow limited

movement of outer arm relative to inner arm,

dependent upon tension of screw. Washer (80)

will lock arms together. See "ADJUSTMENT" for

detail.

1. Using 3/16" hex key, loosen screw until nut can be

removed (See Figure 20). Retain nut. Screw and

washers may remain in outer arm.

Figure 20: Multi-Dual Arm Modification

2. Lift outer arm from pin (with screw and washers) and

place on protective surface.

3. Remove spacer from pin (See Figure 20).

4. Install washer (80) on pin (See Figure 20).

5. Re-install outer arm (with screw and washers) on pin

(See Figure 20).

6. Insert and hold nut in lower bore of inner arm (See

Figure 20).

7. Tighten screw as required using 3/16" hex key (See

Figure 20).

8. Proceed to "CABLE MANAGEMENT" (for display with

RECESSED mounting holes), or to "DISPLAY

INSTALLATION" (for all other display configurations).

CABLE MANAGEMENT

1. Attach all cables to display.

2. Open the cable management bracket (on height-

adjustable arm only) by sliding it towards the edge of

the arm (See Figure 21).

NOTE: If necessary, cable management bracket attach

screws may be loosened using hex key (30).

DO NOT POSITION

EITHER ARM ASSEMBLY

ALLOWABLE

AREA

IN GRAY SHADED AREA

Item Description Qty

10 COVER, Arm 1 per static

arm

20 SCREW, Phillips Flat Machine, 8-32 x 3/8" 2 per static

arm

30 WRENCH, Hex, 3/32" (provided) 1

40 CABLE TIE, (only provided with certain

models)

2 or 4

50 STRAIN RELIEF TIE (only provided with

certain models)

2 or 4

spacer or 80

nut

Outer arm

Screw & washers

Inner arm

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Chief KWS220B Instruction Manual Page 11

Comments to this Manuals

Related products and manuals for Flat panel accessories Chief KWS220B