Chief KWT110B Installation Manual download pdf (Page 26)

KWT-110 Installation Instructions

Figure 53

3. Close cable management bracket by sliding it back towards

the centerline of the arm.

NOTE:

If necessary, cable management bracket attach screws

may be tightened using 3/16" hex key (Z).

4. Carefully insert cables in cavity located in lower portion of

mount arm. (See Figure 54)

5. Using Phillips screwdriver, install cover (L) with two #8-32 x

3/8" Phillips flat screws (W). (See Figure 54)

Figure 54

6. Tuck cable inside cable management flap. (See Figure 55)

7. Remove side cover to wall track accessory.

8. Pull cable through cable management flap until cable outlet

plug extends outside the wall track accessory. (See Figure

55)

9. Reinstall side cover making sure the cable runs through the

cable hole. (See Figure 55)

Figure 55

Display Mount Adjustments

Swing Arm

PIVOT / SWING

1. Using 3/16" hex key (Z), slightly loosen or tighten the

adjustment screw(s) as necessary. (See Figure 56)

Figure 56

Height Adjustable

1. Using 5/32" hex key, slightly loosen or tighten the

adjustment screw as necessary. (See Figure 57)

• If display settles on its own, then rotate

adjustment screw counterclockwise (towards the

"+" symbol).

• If display rises on its own, then rotate adjustment

screw clockwise (towards the "-" symbol).

NOTE: It may be necessary to raise or lower the height

adjustable arm to expose the adjustment screw.

Cable Management

Bracket (in open position)

Cable Path (typical)

Cable Path

(typical)

(L) x 1

(W) x 2

cable management flap

cable path

(typical)

Adjustment Screws

1 2 ... 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Chief KWT110B Installation Manual Page 26

Comments to this Manuals

Related products and manuals for Mounting kits Chief KWT110B