Chief PAC735 User Manual download pdf (Page 5)

Installation Instructions PAC735

ASSEMBLY AND INSTALLATION

Assemble Base Support (Cart Installation

ONLY!)

NOTE: If installing PAC735 to a stand rather than a cart, the

base support is not needed as the PAC735 will sit

directly on the base of the stand. Proceed to Mount

Storage Cabinet section.

1. Place left wedge plate (B) and right wedge plate (C) on a flat

surface with threaded bolts facing up. (See Figure 1)

2. Place front cross bar (E) and rear cross bar (F) on top of

wedge plates and insert bolts through corresponding holes

on cross bars. (See Figure 1)

3. Install eight 5/16-18" hex nuts (J) over each threaded bolt

and tighten until cross bars are secured to wedge plates.

(See Figure 1)

Figure 1

Attach Base Support to Cart

1. Partially install two 5/16-18 x 1/2" square head cap screws

(H) and two 1/4" flat washers (K) into side holes on wedge

plates. DO NOT TIGHTEN! (See Figure 2)

NOTE: Screws should protrude approximately 1/8" beyond

wedge plate edge.

Figure 2

2. Slightly loosen (approximately three turns) the front button

head cap screw on either side of the cart base. (See Figure 3)

NOTE: Only one screw should be loosened on only one side

of the cart base.

3. Place base support inside legs of cart and push toward cart

back. (See Figure 3)

Figure 3

(B)

(C)

(E)

(F)

(J) x 8

(H) x 2

(K) x 2

Cart

Base support

1 2 3 4 5 6 7 8

No comments

Chief PAC735 User Manual Page 5