Chief PNRIWUB Installation Manual download pdf (Page 6)

PNRIW Series Installation Instructions

Installation

The following procedure assumes that a Chief Listed Model

PAC501 In-Wall accessory has previously been installed

following the installation instructions provided with the PAC501.

If a PAC501 is not installed or there are any other questions

regarding the installation of this accessory, immediately contact

a Chief Customer Service representative.

WARNING: IMPROPER INSTALLATION CAN LEAD TO

MOUNT FALLING CAUSING SEVERE PERSONAL INJURY

OR DAMAGE TO EQUIPMENT! DO NOT deviate from

installation instructions provided. DO NOT substitute

hardware.

1. Align mounting holes in swing arm UPPER and LOWER

mounting brackets with four mounting holes in PAC501.

(See Figure 1)

Figure 1

2. Secure swing arm to PAC501 using four button head cap

screws (C), four lock washers (D) and four flat washers (E).

(See Figure 2)

Figure 2

Trim Installation

To install optional trim;

1. Remove paper covering adhesive and affix three tape

squares (F) to inside lower flange of each trim piece (B).

(See Figure 3)

2. Orient trim pieces (B) as shown in figure below.

(See Figure 3)

3. Remove paper covering adhesive back from tape squares

(F) on trim and press trim (B) against inner wall of box.

(See Figure 3)

Figure 3

Upper Mounting Bracket

Lower Mounting Bracket

(E) x 4

(D) x 4

(F) x 12

(B) x 4

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Chief PNRIWUB Installation Manual Page 6