Chief ICMPFM2T03 Installation Manual download pdf (Page 11)

Installation Instructions iCMPFM2 / iCMPTM2

INSTALLATION

The iCMPFM2 and iCMPTM2 have been designed to be

mounted directly onto either a wood stud or concrete wall. The

iCMPFM2 has static brackets which keep the TV in an upright

position. The iCMPTM2 has brackets which allow the TV to be

tilted.

WARNING: IMPROPER INSTALLATION CAN LEAD TO

MOUNT FALLING CAUSING SEVERE PERSONAL INJURY

OR DAMAGE TO EQUIPMENT! It is the installers

responsibility to make certain the structure to which the

mount is being attached is capable of supporting five times

the weight of the iCMPFM2 or iCMPTM2 and all attached

equipment not to exceed 125 lbs (56.7 kg).

Assembling the Wall Mount

1. Place both wall uprights (F) on the floor.

2. Slide rails (A) into wall uprights.

3. Thread endcaps (G) into the end of each rail.

NOTE: Proceed to either the Installing to a Wood Stud Wall

(2a) section or the Installing to a Concrete Wall (2b)

section.

Installing to a Wood Stud Wall

4. Determine the center of the TV screen, and where it should

be located on the wall.

5. Locate the closest stud to the left and right of the selected

location.

NOTE: If the screen area lies over a stud, use that stud and

the stud to either the left or right of it.

6. Line up the diamond on mount with center of screen

marking to determine vertical center.

7. Measure up 6" from the center point to mark location of the

upper mounting slots.

Vertical center

of mount

Center of screen

(A)

(G)

(F)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 103 104

No comments

Chief ICMPFM2T03 Installation Manual Page 11