Chief K3F310B Operations Instructions download pdf (Page 8)

K3F310 Installation Instructions

2. When arms are at desired pivot position, lock pivot position

by tightening pivot adjustment screws using 5/16" hex key

(N). (See Figure 10)

Figure 10

Height Adjustment

NOTE: Height adjustment for center display should be set prior

to installing display. Due to the location of the height

adjustment screws for the center display, the center

display will need to be removed in order to adjust the

height. (See Figure 11)

1. Loosen height adjustment screws for specific display that

will be adjusted. (See Figure 11)

2. Adjust arm or display to desired height. (See Figure 11)

3. Tighten height adjustment screws to lock display’s position.

(See Figure 11)

Figure 11

Arm Extension

NOTE: For smaller displays or if converting to a 2x1 array,

faceplate assemblies may be removed and reattached

to fixed part of the arm. See Faceplate Assembly

Section - Outside Faceplates for details.

1. Turn arm extension adjustment knob counter-clockwise on

arm to be adjusted. (See Figure 12)

2. Adjust arm extension as desired. (See Figure 12)

3. Turn arm extension adjustment knob clockwise on adjusted

arm to lock position. (See Figure 12)

Figure 12

Faceplate Assembly Removal

Center Faceplate

NOTE: Center faceplate may be removed to create a 2 x 1

display solution.

1. Remove column cap (D) from array column. (See Figure 13)

2. Loosen height adjustment screws for center faceplate

assembly. (See Figure 13)

3. Slide faceplate assembly up through column channel until it

is removed from column. (See Figure 13)

pivot adjustment screws

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Chief K3F310B Operations Instructions Page 8