Chief K3F310B Operations Instructions download pdf (Page 7)

Installation Instructions K3F310

CAUTION: Using screws of improper size may damage

your display! Proper screws will easily and completely thread

into display mounting holes.

3. Using Phillips screwdriver, carefully install two selected

screws (J or H) through selected spacers (L or M) into the

upper mounting holes on the display. Thread screws

completely into display, then back out 3 complete turns.

(See Figure 7)

4. Pick up and align display so that screws (K) (installed on the

back of the display in the previous step) fit into the mounting

holes on the faceplate. Lower the display firmly into place.

(See Figure 7)

Figure 7

5. Slide two remaining selected spacers (L or M) in between

faceplate and display, positioning them over the lower two

mounting holes. (See Figure 8)

6. Install two remaining selected screws (J or H) through lower

two mounting holes on faceplate, selected spacers (L or M)

into the lower mounting holes on the display. (See Figure 8)

Figure 8

7. Tighten all four screws. Do not overtighten!

Adjustments

Pivot Adjustment

1. Array arms may pivot toward the front of mount up to 15° per

arm. (See Figure 9)

WARNING: Pivoting array arms toward the back of mount

may cause K3F310 mount to tip over causing serious

personal injury or damage to equipment! Do not pivot arms

toward back of mount! (See Figure 9)

Figure 9

(L or M) x 2

(J or H) x 2

Center faceplate

(array stand not shown for clarity)

(L or M) x 2

(J or H) x 2

Center faceplate

(array stand not

shown for clarity)

front

(top view)

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Chief K3F310B Operations Instructions Page 7