Chief CM2C40U Installation Manual download pdf (Page 6)

CM2C40 Installation Instructions

INSTALLATION REQUIREMENTS

The CM2C40 has been designed to be mounted either hanging

from an overhead structure or mounted to existing stud wall

structures.

WARNING: IMPROPER INSTALLATION CAN LEAD TO

LIFT TIPPING CAUSING SEVERE PERSONAL INJURY OR

DAMAGE TO EQUIPMENT! It is the installers responsibility

to make certain the structure to which the lift is being

mounted is capable of supporting 4 times the weight of the lift

and all attached equipment.

Power Requirements and Wiring

The CM2C40 requires 120VAC (220/240VAC 50 Hz for

European installations) power to operate.

A 6’ long power cable is provided with the mount.

INSTALLATION

Pre-Installation Configuration and Adjustments

Prior to being installed, the CM2C40 requires the configuration

of the mount for display, cable installation and routing, and the

rough adjustment of the top cover mounting bracket.

To prepare the CM2C40 for Installation:

1. Remove mount from box.

2. Remove two wooden supports from under box.

3. Lay two wooden supports on floor and mount CM2C40 to

supports using four 5/16" flat washers and four

5/16" x 2-1/2" lag bolts (hardware provided). (See figure 1)

Figure 1

Configuring the Mount for the Display

Prior to installation, the CM2C40 needs to be configured for the

size of the display being used.

To prepare the CM2C40 for the display being installed:

1. Install interface bracket or mounting buttons to display

following the instructions provided with bracket.

2. Measure the distance from the center of an upper mounting

button to the highest point of the display.

3. Record measurement.

Figure 2

IMPORTANT ! : If the dimension taken in figure 2 is greater

than 13.5" (342.9mm), the faceplate will need to be adjusted

before mounting the display. If the dimension taken in figure 2

is less than 13.5" (342.9mm) proceed to Cable installation and

Routing below.

Adjusting Faceplate Location

The CM2C40 is designed to allow up to 6.5" of adjustment. Up

to 2" by adjusting the faceplate location on the faceplate

mounting bracket, and up to an additional 4.5" by adjusting the

faceplate mounting bracket.

Subtract 13.5" from the dimension determined in figure 2. The

difference between the two is the total amount of adjustment

the faceplate will require.

If 2" or less faceplate adjustment is required proceed to step 5.

If more than 2" of faceplate adjustment is required proceed to

step 8.

NOTE: Depending upon the amount of faceplate adjustment

required, it maybe necessary to adjust both the

faceplate and faceplate mounting bracket.

If 2" or less faceplate adjustment is required:

4. Install IR receiver. (See figure 3)

5. Plug appropriate power cord into mount and power source.

6. Using the remote control, raise lift until locknuts on back

side of faceplate can be accessed. (See figure 3)

WARNING: PINCH HAZARD! FINGERS OR HANDS

BETWEEN MOVING PARTS CAN LEAD TO SEVERE

PERSONAL INJURY! Keep fingers and hands away from

mount when operating.

Lag Bolt

Flat Washer

Wooden Supports

(from bottom of box)

Example:

Dimension from Step 2 = 15"

15" - 13.5" = 1.5" (Amount of faceplate adjustment required)

1 2 3 4 5 6 7 8 9 10 11 ... 75 76

Comments to this Manuals

No comments

Chief CM2C40U Installation Manual Page 6

Comments to this Manuals

Related products and manuals for Flat panel ceiling mounts Chief CM2C40U