Chief KSA1020B Installation Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
Installation Instructions KSA-1020
5
5. Loosen adjustment knobs on top and bottom of the mount
and slide flanges in order to allow for the CPU to be inserted
for mounting. (See Figure 5)
NOTE: Top and bottom knobs can be removed and inserted
into the front square holes in order to allow for large
CPU’s to be installed. (See Figure 5)
NOTE: Flanges may be reversed in order to allow for narrow
CPU’s to be installed in a secure manner. If this is
done, be sure to also remove and reinstall strap so that
the buckle is facing out for easy adjustment.
Figure 5
6. Set CPU in CPU mount (A). (See Figure 6)
7. Use adjustment knobs to compress mount around CPU until
CPU is tightly secured in mount (A). (See Figure 6)
Figure 6
8. Tighten front strap to desired tension.
WALL MOUNT INSTALLATION
WARNING: FAILURE TO PROVIDE ADEQUATE
STRUCTURAL STRENGTH FOR THIS MOUNT CAN
RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE
TO EQUIPMENT! It is the installers responsibility to make
sure the structure to which this mount is attached can support
five times the combined weight of the mount and all
equipment attached to it. Reinforce the structure as required
before installing the mount.
NOTE: Mount may be installed using 2" x 4" wood studs, steel
studs or it may be installed directly into drywall. For
steel stud and drywall installation, proceed to Site
Requirements for Using Steel Studs section. For
desk mounting, proceed to Installing to Desk section.
Installing to Wood Studs
1. Determine location for mount keeping in mind CPU size and
safety requirements.
2. Use the removed mounting bracket as a template and mark
through top and bottom holes of wall bracket. (See Figure 7)
3. Drill two 7/64" diameter pilot holes at marked spots into
wood stud. (See Figure 7)
Figure 7
4. Install two #12 x 2-1/2" Phillips wood screws (G) through
bracket and drywall into wood stud. (See Figure 7)
5. Ensure bracket is vertical, then tighten screws (G).
NOTE: Proceed toMounting CPU to Wall section to complete
installation.
5
5
7
7
CPU
2
3
(G) x 2
mounting bracket
Page view 4
1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments