Chief YSM2 User Manual download pdf (Page 6)

YSM2 Installation Instructions

Steel Stud Installation - Site Requirements

WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY

OR DAMAGE TO EQUIPMENT! The figure below identifies the minimum reguirements for installation of display mounts onto a

steel stud structure. If the structure or its components do not meet these requirements contact the mount manufacturer for specific

instructions before attempting installation. It should also be noted that no other equipment should be mounted to the same stud.

Figure 3

If back side of wall is unfinished, drywall must be installed

to a minimum of one stud left and right of the stud(s)

being used to install the mount.

Steel Stud (2 x 4 / 25ga minimum)

Drywall

5/8" minimum

Drywall Thickness

Display Mount Installation Location

FRONT

(Both Sides of Stud)

(Must be centered over two studs)

There must be a minimum of

1-7/8" (48mm) clearance

inside wall

1 2 3 4 5 6 7 8 9 10

No comments

Chief YSM2 User Manual Page 6