Chief XCB7000 Installation Manual download pdf (Page 8)

XCB7000 Installation Instructions

8. Tighten two 5/16" x 3/4" set screws (BB) through each array

head (FF) and against column. (See Figure 8)

Figure 8

Attaching Add-On Heads

1. Attach add-on head (GG) to existing array head using four

5/16 x 5/8" button head cap screws (JJ). (See Figure 9)

2. Repeat Step 1 for remaining add-on head.

Figure 9

Adding Mounting Rail

1. Slide four T-slot studs (EE - two in top mounting rail slot and

two in bottom) into end of mounting rail (MM). (See Figure 10)

Figure 10

2. Partially fasten one 5/16" lock nut (KK) to each stud on

upper T-slot studs.

3. Slide top T-slot studs (EE) with attached lock nuts (KK)

down into top openings on add-on heads (FF). (See Figure

11)

Slide studs on lower T-slot studs (EE) into lower slots on

add-on heads (FF) while bringing mounting rail against add-

on heads.

IMPORTANT ! : Both mounting rails (MM) must be

located at the same height. One mounting rail must NOT

be higher than the other mounting rail.

5. Tighten array head to mounting rail by tightening lock nuts

on upper T-slot studs and adding two 5/16" lock nuts (KK) to

lower T-slot studs. (See Figure 6)

Figure 11

6. Repeat for remaining add-on head (FF).

(BB) x 2

(FF)

(JJ) x 4

(GG)

(EE) x 4

(MM)

(KK) x 2

(FF)

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Chief XCB7000 Installation Manual Page 8