Chief MPAUB Installation Manual download pdf (Page 10)

MPAU Installation Instructions

8. Route cables down column channel, tucking them behind

height-adjustment carriage and underneath bracket holding

height-adjustment shaft. (See Figure 14)

9. Wrap cables around cable hooks hooks as desired. (See

Figure 14)

10. Snap back cover (G) onto back of column assembly making

sure cables fit through opening at bottom of cover. (See

Figure 14)

Figure 14

Adjustments

Height Adjustment

1. Remove cable cover (G) to expose height adjustment knob.

2. Turn height adjustment knob clockwise to raise display.

(See Figure 15)

3. Turn height adjustment knob counterclockwise to lower

display. (See Figure 15)

WARNING: Do not attempt to raise or lower the adjustment

carriage beyond its upper or lower limit. High and low points

are shown in Figures 15 and 16.

NOTE: A 1/2" socket wrench may also be used to adjust height

by turning bolt just above height adjustment knob.

4. Reinstall cable cover (G) to column assembly.

Figure 15

Figure 16

(G)

cable opening

cable hooks

(rear view)

under bracket

high point

height adjustment knob

low point

1 2 ... 5 6 7 8 9 10 11 12

No comments

Chief MPAUB Installation Manual Page 10