Chief FCA103 User Manual download pdf (Page 5)

Installation Instructions FCA103

INSTALLATION

Locate Mounting Site

WARNING: Exceeding the weight capacity can result in

serious personal injury or damage to equipment! It is the

installer’s responsibility to make sure the combined weight of

all components atttached to the FCA103 does not exceed

250 lbs (113.4 kg) or the maximum weight limit of the specific

Fusion mount being attached. The maximum weight that can

be installed onto the FCA103 shelf is 30 lbs (13.6 kg).

The FCA103 can be installed to either wood studs or a concrete

wall. The minimum distance between fasteners must be 16"

whether installing to 2" x 4" wood studs or concrete.

NOTE: Proceed to either theInstalling to a Wood Stud Wall

section or the Installing to a Concrete Wall section.

NOTE: If already installed, Fusion mount must be uninstalled

prior to FCA103 installation. Set aside wall mounting

hardware as it will be used again for FCA103 mounting.

Installing to a Wood Stud Wall

1. Determine the center of the TV screen, and where it should

be located on the wall.

2. Locate the closest 2" x 4" stud to the left and right of the

selected location.

NOTE: If the screen area lies over a stud, use that stud and the

stud to either the left or right of it.

3. Line up the notches on mount (A) with center of screen

marking to determine vertical center. (See Figure 1)

4. Measure up 8 3/4" (222.2 mm) from the center point to mark

location of the upper mounting slots.

Figure 1

5. Using a level, mark the wall on each stud to attach the

brackets through the upper mounting slots. (See Figure 2)

WARNING: ELECTRICAL SHOCK HAZARD! CUTTING

OR DRILLING INTO ELECTRICAL CORDS OR CABLES

CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY!

ALWAYS make certain area behind mounting surface is free

of electrical wires and cables before drilling or installing

fasteners.

WARNING: EXPLOSION AND FIRE HAZARD! CUTTING

OR DRILLING INTO GAS PLUMBING CAN CAUSE DEATH

OR SERIOUS PERSONAL INJURY! ALWAYS make certain

area behind mounting surface is free of gas, water, waste, or

any other plumbing before cutting, drilling, or installing

fasteners.

6. Drill one 7/32" (5.5mm) pilot hole in each stud.

7. Use two 5/16 x 2-1/2" lag bolts and two 5/16" flat washers

to attach top of brackets (A and B) to wall. (See Figure 2)

NOTE: If desired CPU location is off to the side of the display,

reverse brackets (A and B) from how they are shown in

Figure 2.

Figure 2

8. Mark the attachment points for the lower mounting slots,

making sure the attachment points are located on the studs.

(See Figure 2)

9. Drill 7/32" (5.5mm) pilot holes at markings for lower

mounting holes. (See Figure 2)

10. Use two 5/16 x 2-1/2" lag bolts and two 5/16" flat washers

to attach the mount to the wall through the lower mounting

holes. (See Figure 2)

11. Proceed to Installing Shelf to Brackets Section.

Center of screen

8-3/4"

Vertical center

of mount

(222.2mm)

x 4

(A)*

(B)*

*reverse brackets to install CPU shelf to the outside

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Chief FCA103 User Manual Page 5

Comments to this Manuals

Related products and manuals for Hardware Chief FCA103