Chief NW1 Series User Manual download pdf (Page 7)

Installation Instructions NW1 Racks

Latch Assembly

5. Add latch assembly (K) to inside of rack center section (B)

using two 10-24 x 3/8" button head security screws (C) from

outside of rack.

6. Open rack by pushing down on outside end of latch

assembly. (See Figure )

Figure 6

Adjusting Rack Rail

The rack rails may be adjusted. (See Figure 7)

7. Loosen rack rail screws and nuts from side braces.

NOTE: The number of rack rail screws varies dependent on

rack model.

8. Slide rack rail forward or back, as required.

9. Tighten rack rail screws into nuts, and torgue to 5 ft-lbs.

Figure 7

LOADING THE RACK

NOTE: The alignment panels shipped with the racks are

optional. They may be removed to facilitate loading of

the racks.

Load Distribution

CAUTION: BEGIN PLACEMENT OF LOAD AT BOTTOM

OF RACK! Load rack, moving from bottom toward top of rack.

Loading rack incorrectly may result in instability causing

possibly injury and/or damage to components.

1. Begin placement of components into the rack at the lowest

point.

NOTE: Continue placing items into the rack, moving from the

bottom upward.

CAUTION: The top of the unit should not be used as a

shelf.

CAUTION: DISTRIBUTE LOAD CORRECTLY! Load rack

with 2/3 total weight of components in the lower half of rack.

Loading rack incorrectly may result in instability causing

possible injury and/or damage to components.

(K)

(B)

Side brace

Rack

rail

1 2 3 4 5 6 7 8

No comments

Chief NW1 Series User Manual Page 7