Chief MSM1U Manual download pdf (Page 12)

MSM1U/MTM1U/LSM1U/LTM1U Installation Instructions

Adjustments

Horizontal Adjustment

1. The mount wall brackets may be adjusted side to side at the

point of attachment. (See Figure 12)

Figure 12

2. The screen may be adjusted along rails side to side.

NOTE: NEVER place both interface brackets (Y and Z or AA

and BB) to one side of the wall mount center line! (See

Figure 10)

NOTE: Do NOT allow both interface brackets (Y and Z or AA

and BB) to be located on same side of wall bracket.

(See Figure 10)

3. (MTM1U / LTM1U only) Move latch on top of interface

brackets to CLOSED position. (See Figure 14)

Roll/Height Adjustment of Wall Brackets

NOTE: The height adjust wall brackets allow adjustment of

1/2".

1. Turn to right (tighten) to raise side of screen. (See Figure 13)

2. Turn to left (loosen) to lower side of the screen.

Figure 13

Tilt (MTM1U / LTM1U Only)

The interface brackets (AA and BB) allow from -2° to 12° tilt,

and can be locked at 0°, 6° and 12°.

1. Loosen the interface bracket knob.

2. Adjust tilt as required. (See Figure 14)

3. The tilt may be locked at 0°, 6° or 12° using one 1/4-20 x 1"

round head carriage bolt (V) and one 1/4-20 hex nut (W) per

interface bracket. (See Figure 14)

4. Tighten interface bracket knob as necessary.

Figure 14

3" horizontal

adjustment possible

Raises screen

Lowers screen

(S)

(Screen not shown for clarity)

Latch in

CLOSED

position

(W)

(V)

Lock at 12° tilt

Lock at 6° tilt

Lock at 0° tilt

Interface

bracket

knob

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Chief MSM1U Manual Page 12

Comments to this Manuals

Related products and manuals for Flat panel wall mounts Chief MSM1U