Chief K0W100B Installation Manual download pdf (Page 8)

K0 Series Installation Instructions

4. Position display with faceplate attached above mount. (See

Figure 6)

5. Slide faceplate onto mounting head until quick release tab

clicks into place. (See Figure 6)

Figure 6

Adjustments

Pitch Adjustment

1. Adjust pitch to desired tilt position. (See Figure 8)

2. Adjust pitch tension screw to change the adjustment

tension. (See Figure 8)

Pivot Adjustment

3. Adjust pivot position as desired. (See Figure 8)

4. Use 3/16” hex key (N) to adjust pivot point tension screws

to change pivot adjustment tension. (See Figure 8)

Rotational Adjustment

NOTE: (Optional) Rotational adjustment may be locked by

installing rotational locking screw (M) into back of

faceplate. (See Figure 7)

Figure 7

5. The monitor may be adjusted 90 degrees in either direction

in order to provide a portrait view of the monitor. (See Figure

6. Use 3/16” hex key (N) to adjust rotational adjustment screw

to adjust rotational tension. (See Figure 8)

Figure 8

Display Removal

WARNING: Only remove display from mount when the

display can be lifted up from the mount! DO NOT remove

display unless the display is in the upright position! (See

Figure 9)

1. Make sure display is in the upright position.

2. Remove quick release faceplate from mount by pulling

quick release lever and sliding faceplate off mount. (See

Figure 9)

Figure 9

(M)

pitch

pivot point

tension

rotational tension

quick release tab

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Chief K0W100B Installation Manual Page 8